LED Exit Sign Retrofit Kit
Retrofit your existing exit sign fixtures with LED internals instead of replacing them outright, lower energy draw, a 50,000+ hour lifespan, and code-compliant battery backup, installed by Highmark across Florida.
Why Upgrade Instead of Replace
A retrofit kit swaps the internals of an existing exit sign fixture for LED components, no need to tear out and replace the housing, and no electrician required in most cases.
Old incandescent exit signs draw 30–40 watts per unit, run hot enough to damage plastic housings over time, and burn out often enough to add up in maintenance labor. LED retrofit kits solve all three problems while keeping your existing fixture in place.
Old Incandescent vs. LED Retrofit
Energy Use
Less than 5 watts per unit, versus 30–40 watts for incandescent, up to 90% savings on electricity.
Lifespan
50,000+ hour LED lifespan versus frequent incandescent bulb replacement.
Heat Output
Reduced heat output prevents damage to plastic sign housings.
Visibility
LEDs cut through smoke more effectively and remain visible from 100 feet or more.
Battery Backup
Meets or exceeds the 90-minute code requirement.
Code Compliance
Meets OSHA and NFPA standards under Florida Fire Code and Life Safety Code requirements.
Installation
Retrofit kits use universal connectors that screw directly into existing sockets, and universal mounting systems keep them compatible with 99% of existing sign fixtures. Most facility maintenance teams can install a unit in under 15 minutes, no complex rewiring and, in many cases, no electrician needed.
Return on Investment
Between reduced energy bills and the elimination of labor costs for replacing burnt-out bulbs, most facilities see a full payback in under 12 months. After that, it’s essentially install-and-forget with very low ongoing maintenance cost.